A8511KLPTR-T

Allegro MicroSystems
250-A8511KLPTR-T
A8511KLPTR-T

제조업체:

설명:
LED 조명 드라이버 IC BACKLIGHT DRIVER for LARGE SIZE LCDs

라이프사이클:
NRND:
새로운 디자인에 권장되지 않습니다.
ECAD 모델:
무료 라이브러리 로더를 다운로드하여 이 파일을 ECAD 도구용으로 변환하십시오. ECAD 모델에 대해 자세히 알아보기

재고 상태: 7,987

재고:
7,987 즉시 배송 가능
7987을(를) 초과하는 수량에 대해서는 최소 주문 요구사항이 적용됩니다.
최소: 1   배수: 1
단가:
₩-
합계:
₩-
예상 관세:

가격 (KRW)

수량 단가
합계
₩8,322 ₩8,322
₩5,796.2 ₩57,962
₩5,402 ₩135,050
₩4,745 ₩474,500
₩4,511.4 ₩1,127,850
₩4,044.2 ₩2,022,100
₩3,416.4 ₩3,416,400
₩3,285 ₩6,570,000
전체 릴(4000의 배수로 주문)
₩3,270.4 ₩13,081,600

제품 속성 속성 값 속성 선택
Allegro MicroSystems
제품 카테고리: LED 조명 드라이버 IC
RoHS:  
1 Output
Boost
600 mA
TSSOP-28
21 V
8 V
REGS AND LIGHTING
- 40 C
+ 125 C
Reel
Cut Tape
브랜드: Allegro MicroSystems
습도에 민감: Yes
장착 스타일: SMD/SMT
제품 유형: LED Lighting Drivers
팩토리 팩 수량: 4000
하위 범주: Driver ICs
공급 전류 - 최대: 15 mA
제품을 찾음:
유사 제품을 표시하려면 확인란을 하나 이상 선택하십시오.
이 카테고리에 유사 제품을 표시하려면 확인란을 하나 이상 선택하십시오.
속성 선택됨: 0

이 기능을 활성화하려면 자바스크립트가 필요합니다.

CAHTS:
8542310000
USHTS:
8542310075
TARIC:
8542399000
ECCN:
EAR99

IS32LT3175N/P Single-Channel Linear LED Drivers

ISSI IS32LT3175N/P Single-Channel Linear LED Drivers come with fade in/out and PWM dimming. The regulators serve as a stand-alone LED driver-configurable from 20mA to 150mA with external resistors, no microcontroller is necessary. A logic level “courtesy light” signal from the PWM pin can be interfaced to precisely drive the LED channel. The IS32LT3175P obtains a positive polarity PWM signal. In addition, the IS32LT3175N obtains a negative polarity PWM signal. The regulator integrates a 63-step fade-in and fades out the algorithm (Gamma correction). This causes the output LED current to increasingly rise up to the full source value after the EN pin is pulsed.

A8511 Multioutput WLED/RGB Driver

Allegro MicroSystems A8511 Multioutput WLED/RGB Driver is a fully integrated high-brightness (HB) LED driver solution for medium-size backlighting displays. The flexible A8511 driver does not require external power devices to complete the backlighting design criteria. The A8511 integrates FETs for a boost converter and four 150mA current sinks, delivering a complete integrated solution at HB LED current levels. The device's LED channels allow up to 600mA sink capability when tied together. The A8511 works from a single power supply of 6.8V to 21V and withstand up to 40V. The operating frequency can be set to 2MHz, avoiding interference with the AM radio band. The integrated boost DMOS switch is rated for 40V at 3.6A. PWM dimming allows LED currents to be controlled up to a 1000:1 ratio. Additional 4:1 dimming can be achieved by using the DIM pin.