MP3363GJ-Z

Monolithic Power Systems (MPS)
946-MP3363GJ-Z
MP3363GJ-Z

제조업체:

설명:
LED 조명 드라이버 IC Single String, 1.8V Vin-min, 36V Vout Boost LED Driver

ECAD 모델:
무료 라이브러리 로더를 다운로드하여 이 파일을 ECAD 도구용으로 변환하십시오. ECAD 모델에 대해 자세히 알아보기

구매 가능 정보

재고:
재고 없음
공장 리드 타임:
18 주 추정 공장 생산 시간입니다.
최소: 3000   배수: 3000
단가:
₩-
합계:
₩-
예상 관세:
본 제품의 배송비는 무료

가격 (KRW)

수량 단가
합계
전체 릴(3000의 배수로 주문)
₩1,417.8 ₩4,253,400
₩1,389.7 ₩8,338,200

대체 포장

제조업체 부품 번호:
포장:
Reel, Cut Tape
구매 가능 정보:
재고 상태
가격:
₩3,374
최소:
1

유사 제품

Monolithic Power Systems (MPS) MP3363GJ-P
Monolithic Power Systems (MPS)
LED 조명 드라이버 IC Single String, 1.8V Vin-min, 36V Vout Boost LED Driver

제품 속성 속성 값 속성 선택
Monolithic Power Systems (MPS)
제품 카테고리: LED 조명 드라이버 IC
RoHS:  
1 Output
Boost
TSOT23-8
36 V
1.8 V
200 kHz to 2.2 MHz
MP3363
- 40 C
+ 125 C
Open/Short LED Protection, Short FB to GND Protection, Thermal Shutdown, Soft Start
Reel
브랜드: Monolithic Power Systems (MPS)
COA(최종 조립 국가): Not Available
COD(확산 공정 국가): Not Available
COO(원산지): Not Available
개발 키트: EV3363-J-00A
디밍: Analog, PWM
연동 사용 대상: General Lighting
입력 전압: 1.8 V to 36 V
장착 스타일: SMD/SMT
채널 수: 1 Channel
Pd - 전력 발산: 1.25 W
제품: LED Drivers
제품 유형: LED Lighting Drivers
팩토리 팩 수량: 3000
하위 범주: Driver ICs
제품을 찾음:
유사 제품을 표시하려면 확인란을 하나 이상 선택하십시오.
이 카테고리에 유사 제품을 표시하려면 확인란을 하나 이상 선택하십시오.
속성 선택됨: 0

CAHTS:
8542390000
USHTS:
8542390090
TARIC:
8542399000
MXHTS:
8542399999
ECCN:
EAR99

MP3363 Boost LED Drivers

Monolithic Power Systems (MPS) MP3363 Boost LED Drivers offer an ideal solution for low-current and high-current boost applications. The MP3363 provides a low 0.2V feedback voltage (VFB), allowing higher efficiency in white LED driver applications. The device regulates the output voltage (VOUT) up to 36V, with an efficiency as high as 95%. Additionally, the current mode regulation and external compensation components permit the MP3363 control loop to be optimized across a wide variety of input voltages.

IS32LT3175N/P Single-Channel Linear LED Drivers

ISSI IS32LT3175N/P Single-Channel Linear LED Drivers come with fade in/out and PWM dimming. The regulators serve as a stand-alone LED driver-configurable from 20mA to 150mA with external resistors, no microcontroller is necessary. A logic level “courtesy light” signal from the PWM pin can be interfaced to precisely drive the LED channel. The IS32LT3175P obtains a positive polarity PWM signal. In addition, the IS32LT3175N obtains a negative polarity PWM signal. The regulator integrates a 63-step fade-in and fades out the algorithm (Gamma correction). This causes the output LED current to increasingly rise up to the full source value after the EN pin is pulsed.